Gypsum Plasterboard Manufacturing With 2Million m2 Capacity

Plasterboard equipment Drying system: along with dryer, transmission system, warmth exchanger, fan circulation system, dehumidification machine and different equipment. During the procedure of gypsum board on foot in the drying kiln, the inside water is evenly eliminated to preserve the water content material of gypsum board completed merchandise in the vary of 2% - 3%. In the drying system, the temperature of every place in the drying kiln can be routinely monitored, and the dehydration and drying excellent of gypsum board can be ensured by means of adjusting the jogging velocity and moisture discharge of gypsum board in the drying kiln.

Plasterboard equipment Dryer discharge system: the fundamental tools consists of discharge machine, acceleration curler desk and conveyor belt. The tools in this phase normally transports the dried gypsum board out of the dryer layer by means of layer from the drying kiln in sequence, and then to the two transverse part. Through PLC and on-site sensor, the function of gypsum board in the outgoing section can be detected automatically, and the outgoing method can be finished routinely via PLC program
Plasterboard equipment two ＃ transverse part: the essential gear consists of transverse plate feeding curler table, laminating machine, alignment system, sawing system, edging desktop and different auxiliary equipment. After passing via the laminating machine, the the front of the two gypsum boards are easily combined, and the returned corresponds to the outside, so as to facilitate the sawing and packaging of gypsum boards. The uneven edges at each ends of gypsum boards are reduce off in the edging machine, and then enter the edging machine, Enter the stacking device after side sealing at each ends