Gypsum Plasterboard Manufacturing

Plasterboard machinery Drying system: including dryer, transmission system, heat exchanger, fan circulation system, dehumidification system and other equipment. During the process of gypsum board walking in the drying kiln, the internal water is evenly removed to keep the water content of gypsum board finished products in the range of 2% - 3%. In the drying system, the temperature of each area in the drying kiln can be automatically monitored, and the dehydration and drying quality of gypsum board can be ensured by adjusting the running speed and moisture discharge of gypsum board in the drying kiln.

Plasterboard machinery Dryer discharge system: the main equipment includes discharge machine, acceleration roller table and conveyor belt. The equipment in this part mainly transports the dried gypsum board out of the dryer layer by layer from the drying kiln in sequence, and then to the 2 transverse part. Through PLC and on-site sensor, the position of gypsum board in the outgoing part can be detected automatically, and the outgoing process can be completed automatically through PLC program

Plasterboard machinery 2 ＃ transverse part: the main equipment includes transverse plate feeding roller table, laminating machine, alignment system, sawing system, edging machine and other auxiliary equipment. After passing through the laminating machine, the front of the two gypsum boards are smoothly combined, and the back corresponds to the outside, so as to facilitate the sawing and packaging of gypsum boards. The uneven edges at both ends of gypsum boards are cut off in the edging machine, and then enter the edging machine, Enter the stacking system after edge sealing at both ends